Kathrein Euroline UFE 305/S - Manual (Page 20)

Installation menu
20
Adjusting the LNB
In this menu, you can configure your receiver for your antenna:
- Select LNB type (standard-programming for universal LNBs)
- LNB supply voltage
- DiSEqC™ switch V1.0
- DiSEqC™ entry
- Repeat DiSEqC™: If the receiver is operated on a reception
installation with one or more cascaded DiSEqC™ switching
matrix (matrices), the DiSEqC™ command must be repeated.
In this case, switch to '1' or '2' in menu item 'repeat DiSEqC™'
- 22 kHz switch: In this menu item, you can determine whether
the 22 kHz signal is to be used to switch between the high and
low band of a satellite or between two satellite positions.
The receiver is pre-programmed and delivered with an installation
menu which is protected with the password '0000'.