Keys Fitness KPS-LP2 - Manual (Page 11)

Assembly
11
Step 5
Start by attaching Cable (15) to Main Frame (1). See detail A below.
Insert cable into Pulley A location and then attach Pulley A to Main Frame (1) using one Bolt (36), two
Washers (43), and one Nylon Locknut (42).
Note: Make sure cable is running through the groove of each pulley.
Note: All pulleys use the same hardware to attach to Main Frame (1).
Attach Pulley B to Main Frame (1) and then run cable over top of the pulley.
Run cable though slot in Main Frame (1) at Pulley C location.
Insert Pulley C into Main Frame (1), insure cable runs through bottom side of pulley.
Run cable through Pulley D location and then install Pulley D onto Main Frame (1).
Run cable through Pulley E location and then install Pulley E onto Main Frame (1).
Last, thread cable end into the floating pulley of home gym unit.
Figure 5
Congratulations!
You have completed the assembly
of your new KPS-LP2.
Note: Tighten all hardware securely.