Kicker KX350.2 - Manual (Page 6)

6
KX AMPLIFIERS
When the crossover on your KX series amplifier is set to LOW
PASS, you have the ability to control the output level of the
amplifier from the driver’s seat using the supplied Remote Bass
Level Control.
To mount the controller simply screw the metal bracket to the
chosen location, then slide the housing onto the bracket until it
snaps into place.
Run the cable from the controller to the “Remote Bass” jack on
the amplifier chassis.
Remote Bass Level
Mounting Surface
BACK VIEW
SIDE VIEW
PHONE
CABLE
Installa
tion
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to
send the incoming signal from one Kicker KX series amplifier to
another amplifier or processor without the need for Y cables. The
signal from the PAST jacks is identical to the signal fed to the
amplifier via its RCA input jacks or the High Level inputs and is
not affected by the amplifier’s built in crossover.
Most head units with high voltage outputs should be
capable of driving up to ten amplifiers in a chain.
SOURCE UNIT
To Next Amplifier or Processor
Left +
Left -
Right -
Right +
Speaker
Outputs
RCA
Outputs
WARNING - Use either the Hi-Level or RCA Inputs. Never Both !!