Kalorik USK DA 31066 - Manual (Page 7)

7 DA31066 / 31067 - 091112
Assembly page 7/16
• Plug in the iron and select the temperature by turning the
thermostat dial. If there is water in the reservoir, make sure the
steam regulator is set to OFF position. Wait until the indicator light
goes off, showing that the required temperature has been
reached.
STEAM IRONING
• Fill water in the iron as per the water-filling method above.
• Unwind the power cord.
• Plug the appliance in the socket.
• Set the thermostat dial to MAX position, otherwise water may leak
from the soleplate.
• Put the iron on its heel to warm up, until the indicator light goes
off.
• Set the steam regulator correctly, increase the steam output by
rotating the steam regulator anticlockwise, otherwise decrease
the steam output by rotating it clockwise.
Caution: Set the temperature dial within the steam range ('
' or
' '). If temperature setting is too low, water may drip from
soleplate.
Check the garment label before ironing because some clothes may
be damaged when exposed to steam or water. Typically, synthetic
fabrics, nylon, synthetic silk and silk cannot be ironed with steam
otherwise it may damage the fabric.
BURST OF STEAM / VERTICAL STEAM
The burst of steam feature provides additional steam for
removing stubborn creases.
• Set the thermostat dial button to MAX, wait until the indicator light
goes off.
• Release the steam by pressing the steam button.
• Wait for several minutes and let the steam penetrate through the
fabric, and then release more steam through pressing this button
again.