Kawasaki 840089-1HR User Manual

Page 10

ACCESSORIES

Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.

Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.

If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may experi-
ence a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord (see table on next page).

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS

TOOL CURRENT RATING

CONDUCTOR SIZE IN A.W.G

AMPERE

10FT.

25FT.

50FT.

100FT.

3-6

6-8

8-10

10-12

12-16

16-20

SPECIFICATIONS

Voltage

19.2V

Length of Stroke

22mm (7/8")

Switch

Variable Speed with Brake

Charger Input

120V

60Hz

Charging Time

Approx. 1 hour

No Load Speed (RPM) 0-3200/min
Battery Type

Ni-Cad

PROTECTING THE ENVIRONMENT

BATTERIES
Alltrade batteries can be recharged many times. At the end of their useful life,
recycle batteries with due care for our environment.

Ni-Cad and Ni-MH batteries are recyclable. Take them to your local recycling center
or call 1-800-822-8837. Collected batteries will be recycled or disposed of properly.

MAINTENANCE AND CLEANING

Always remove the battery pack before attempting

cleaning or maintenance.

This Cordless Reciprocating Saw is lubricated before

it leaves the factory. This lubrication should last for the life of the tool. No
further lubrication is required.

Use only mild soap and a damp cloth to clean the tool. Never let any liquid get
inside the casing. Never immerse any part of the tool in a liquid. Always keep the
ventilation openings clear.

Always clean the battery pack using only a dry cloth. Do not use liquids.

Always unplug the charger before cleaning it.

Regularly clean the ventilation slots in your tool and charger using only a soft
brush or dry cloth.

Inspect all mounting screws regularly. Tighten any loose screws. Failure to keep
the mounting screws tight could result in serious injuries.

Never open the Cordless Reciprocating Saw case, battery pack or charger. Do not
attempt to repair the Cordless Reciprocating Saw, battery pack or charger yourself.
Opening any of these parts will void your warranty.

OIL