Kolcraft LITE SERIES S67-T 4/07 - Manual (Page 5)

To Assemble Front Wheels
Place stroller back on handle bars.
Locate “
▲” and “★” underneath Front
Wheel Assembly. Align assembly with
front axle and snap into place as shown.
Repeat for other Front Wheel Assembly.
Tug firmly on each wheel assembly to be
sure wheels are securely in place.
NOTE: To remove, push spring loaded
button in and pull off wheel.
1
2
Left
★
Right
▲
3
5
To Assemble Rear Wheels
Turn stroller over as shown.
Position Rear Axle Assembly as shown,
with red brake levers pointing towards
stroller handle.
Push Rear Axle Assembly onto rear leg
tubes at the same time.
Make sure plastic tabs on rear axle lock
into holes on rear legs as shown.
Slide a Rear Wheel onto the axle then
slide a Washer onto the axle.
Fit straight part of Cotter Pin through
hole on axle as shown.
Line up each of the tabs in the Hub Cap
with the slots in the wheel, snap Hub
Cap into place.
Repeat for second side.
1
2
1 & 2
4
4
5
Tab locks
into hole
5
6
3
7
6
8