Kenwood TK-8180(H) - Manual (Page 2)

ADS#38905 Printed in USA
JQA-QMA1205
■ KMC-35
Microphone
(supplied microphone)
■ KMC-36
Keypad Microphone
■ KMC-32
Keypad Microphone
■ KMC-9C
Control Station
Desktop Microphone
■ KRK-10
Control Head
Remote Kit (23ft/7m)
■ KCT-46
Ignition Sense Cable
■ KCT-40
Radio Interface Cable
(for KDS-100, KGP-2A/2B)
■ KCT-23M
DC Cable (Dash
mount / 10 feet)
■ KCT-23M3
DC Cable (Remote
mount / 23 feet)
■ KAP-2
Horn Alert/Public
Address Relay Unit
■ VGS-1
Voice Guide &
Storage Unit
■ KES-3
External Speaker
■ KES-5
External Speaker
(requires KAP-2)
■ KMB-10
Key Lock Adapter
■ KLF-2
Line Noise Filter
■ KPS-10A
DC Power Supply
■ KPS-15
DC Power Supply
All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete list of all accessories and options.
Model TK-7180 TK-7180H TK-8180 TK-8180H
GENERAL
Frequency Range
Type 1 136~174 MHz 450~520 MHz
Type 2 – 400~470 MHz
Number of Channels*
Conv. Mode Max.32 per Radio
Trunked Network 1023
Channel Spacing
Wide 25 kHz, 30 kHz 25 kHz
Narrow 12.5 kHz, 15 kHz 12.5 kHz
Operating Voltage 13.6 V DC±15 %
Current Drain
Standby 0.4 A 0.4 A 0.4 A 0.4 A
Receive 1.0 A 1.0 A 1.0 A 1.0 A
Transmit 9.0 A 13.0 A 9.0 A 13.0 A
Duty Cycle Transmit: 20 %
Operating Temperature Range -22 ºF ~ +140 ºF (-30 ºC ~ +60 ºC)
Frequency Stability ±0.00025 % (-22 ºF ~ +140 ºF)
Antenna Impedance 50 Ω
Channel Frequency Spread
Type 1 38 MHz 70 MHz
Type 2 – 70 MHz
Dimensions (W x H x D), 6-5/16” x 1-3/4” x 6-3/16”
Projections not included (160 mm x 45 mm x 157 mm)
Weight (net) 3.3 lbs. (1.5 kg)
FCC ID
Type 1 K4437303110 K4437303210 K4437313110 K4437313210
Type 2– – – K4437313120 K4437313220
IC Certification
Type 1 282F-37303110 – – –
Type 2– – – 282F-37313120 –
Model TK-7180 TK-7180H TK-8180 TK-8180H
RECEIVER (Measurements made per EIA/TIA-603)
Sensitivity (12dB SINAD)
Wide 0.25 µV
Narrow 0.28 µV
Selectivity**
Wide 80 dB 80 dB
Narrow 70 dB 67 dB
Intermodulation Distortion
Wide/Narrow 75 dB (±50, 100 kHz)
Spurious Response** 90 dB 85 dB
Audio Output
(4
Ω Impedance) 4 W with less than 5 % distortion
TRANSMITTER (Measurements made per EIA/TIA-603)
RF Output Power
Type 1 30 to 1 W 50 to 10 W 30 to 1 W 45 to 10 W
(490 -520 MHz:25 to 1 W) (490 -520 MHz:40 to 10 W)
Type 2 – – 30 to 1 W 45 to 10 W
Spurious Response 70 dB
Type of Emission
Wide 16K0F3E
Narrow 11K0F3E
FM Hum & Noise
Wide 50 dB
Narrow 45 dB
Microphone Impedance 600 Ω
Audio Distortion
Wide/Narrow 3 %
Standard MIL 810C MIL 810D MIL 810E MIL 810F
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I
Shock 516.2/Procedure I, II, III, V 516.3/Procedure I, IV, V 516.4/Procedure I, IV, V 516.5/Procedure I, IV, V
International Protection Standard
Dust & Water Protection P54: Radio itself
P54/55: Remote Head with KRK-10
*To meet above Mil810 and IP grade, weather proof microphone KMC-35 or KMC-36 has to be connected.
*Maximum capability depends on the number of programmed Zone and repeater channels.
** Typical specifications
Kenwood follows a policy of continuous
advancement in development. For this reason
specifications may be changed without
notice.
Options
Specifications
Applicable MIL-STD & IP
footnotes from Front:
1 Easy Option Port: Supports Encryption boards or VGS-1 only;
ANI boards are not supported. VGS-1: Auto-Reply only operates
in MPT trunked mode. Auto-Record, Voice Memo operates in
Conventional & MPT Trunked modes.
2 DTMF Manual Encode (DTMF microphone required)
3 KCT-46 ignition sense cable option required; plugs into mobile
ignition sense pig-tail cable.
4 KPG-96D required: Windows ® 98/ NT/ 2000/ Me/XP compatible.
5 MIL-STD “Driven-Rain” and IP-55 Water/Dust Intrusion apply
to remote control head only; IP54 applies to radio chassis.
6 Conventional Mode: Mode entry by PF key or auto Mode Change.
Network/Trunking operations are MPT1327/1342 compataible.
7 Special Alert Tone Patterns: enabled for MPT Individual Call, Auto
Mode Change.
8 Companded Audio can be enabled for “all Channels: in Trunked
Mode and per Channel in Conventional Mode.
9 KAP-2 required: Public Address & Horn Alert operate in
MPT mode only.
* TK-8180K/HK models are derated to 25W/ 40W power from
490-512 MHz