Kompernass SFW 250 A1 - Manual (Page 5)

- 3 -
To avoid the risk of accidents and
injuries:
• Never put your hand into the openings of the ap-
pliance. Do not insert any objects of any kind
into the openings – except for the appropriate
stodger and the foodstuff to be processed. If you
do, there will be a serious risk of accidents!
• Unplug the appliance from the power source be-
fore attaching or removing accessories.
• Do not leave the appliance unsupervised when it
is ready for use. To avoid it being switched on
accidentally, always unplug the appliance after
use or during breaks.
• Use only original accessories for this appliance.
Other accessories may not meet the safety
requirements.
• This appliance is not intended for use by individuals
(including children) with restricted physical, physio-lo-
gical or intellectual abilities or deficiences in
experience and/or knowledge unless they are
supervised by a person responsible for their
safety or receive from this person instruction in
how the appliance is to be used.
• Children should be supervised to ensure that
they do not play with the appliance.
• Never operate the appliance in a no-load condi-
tion. This could irreparably damage the
appliance.
5. Assembly / Disassembly
IMPORTANT: All accessories are coated with
a thin film of oil to protect them from corrosion.
Therefore carefully clean all of the parts before
using the appliance for the first time, as com-
prehensively described on chapter "8 Clea-
ning". After subsequent usage, always apply a
light coating of cooking oil to the metallic
components.
a) Assembling the meat grinder
Unfold the fold-out side. There you will find the
step-by-step illustrations for assembling the appliance.
• Place the transport screw
y into the mincer
casing t .
• Place the spring u onto the transport screw y .
• Then place on the cross blade i so that the
sharp side points away from the spring u .
Caution:
The cross blade i is very sharp! Risk of injury!
Important!:
The appliance will be damaged if the cross blade
i is inserted the other way around!
• Select the desired cutting disc. The cutting discs
that are not required can be stored in the small
compartment on the appliance (Fig.
Ả).
To open it, press on the symbol on the cover.
The cover can now be opened. Insert the two
unrequired cutting discs.
• Insert the selected cutting disc o into the meat
grinder casing t , so that the indentations on the
cutting disc o lie on the fixing points in the meat
grinder casing t .
• When everything has been correctly assembled,
screw the ring clamp a on until it is handtight.
IB_62025_SFW250A1_LB6 05.11.2010 14:00 Uhr Seite 3