Kompernass PHKP 500 - Manual (Page 6)

8 GB/IE/CY
4. Careful handling and use of
electrical power tools
a) Pull the mains plug from the socket
before you make any adjustments
to the device, change accessories or
when the device is put away.
This precaution is intended to prevent you from
unintentionally starting the device.
b) When not in use always ensure that
electrical power tools are kept out of
reach of children. Do not let anyone
use the device if he or she is not
familiar with it or has not read the
instructions and advice. Electrical power
tools are dangerous when they are used by
inexperienced people. Let the device cool
down completely before putting it away.
The hot nozzle can cause damage.
c) Look after the device carefully.
Check that moving parts are working
properly and move freely. Check for
any parts that are broken or dam-
aged enough to detrimentally affect
the functioning of the device. Have
damaged parts repaired before you
use the device. Many accidents have their ori-
gins in poorly maintained electrical power tools.
d) Always work with the mains lead leading
away from the rear of the device.
Q
Operation
Q
Before first use
Preparing the glue site:
J
Do not use inflammable solvents to clean the
glue site.
J
The ambient temperature and temperature of
the materials to be glued must be not less than
+5° C and not warmer than +50° C.
J
The glue sites must be clean, dry and free of
grease.
j Smooth surfaces should be roughened before
gluing.
j Warm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.
j Screw on the appropriate nozzle 8 and fit
the wire stand 6 .
Q Preparing the tool for use
Working with the mains lead connected:
1. Connect the mains lead
11 to the glue gun
connection 10 (see Fig. F).
Insert the mains plug into the mains socket.
2. Fold forward the wire stand 6
Stand the device up.
3. Push a glue stick into the feed channel 1 .
4. Let the device heat up for about 4 minutes.
The device is now ready for use.
Cordless working:
1. Connect the mains lead 11 to the charger
connection 3 .
Insert the mains plug into the mains socket.
2. Place the glue gun into the charger.
3. Push a glue stick into the feed channel
1 .
4. Let the device heat up for about 4 minutes.
The device is now ready for use.
5. Repeat the heating-up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.
Gluing:
j Press the feed switch 5 to regulate the flow of
glue as required for your work.
1. Apply the glue in individual dots. Apply in zig-
zags on flexible materials such as fabrics.
2. Immediately after applying the glue, press the
two materials together for about 30 seconds. The
glued joint can be loaded after about 5 minutes.
3. When you take a break from work, set the glue
gun down on the wire stand 6 or in the charger.
4. Remove any glue residue with a sharp knife af-
ter cooling. Glued joints can be loosened
again by applying heat.
Safety notes / Operation