Kicker KS20 - Manual (Page 6)

Installation
6
Installa
tion
KS-Series Tweeters
Wiring
There are two lengths of wires attached to the Kicker KS-Series Tweeter Crossover. One set is labeled “INPUT” and is designed to
connect to the source unit or amplifier. The other set is labeled “KSxx TWEETER” and is designed to connect to the tweeter’s length
of wires, using the supplied butt connectors. Please see Figure 6.
Panel
Longer
Tweeter
Mounting
Nut
Tweeter
Wire
Front
Angle
Ring
Back
Angle
Ring
Figure 5
Tweeter
Butt Butt
Connectors
Connectors +
_
107.5 FM THE END
+
_
+
_
SOURCE UNIT or AMPLIFIER
Figure 6
All specifications and performance figures are subject to change. Please visit kicker.com for the most current information.
Panel
Shorter
Tweeter
Mounting
Nut
Tweeter
Wire
Figure 4
Door Body
Tweeter
Mounting Nut
2" Hole
Door Panel
Clearance Hole 2.5"
Figure 3
all the parts in unison until the tweeter is angled in the desired direction. Secure the assembly by tightening the longer tweeter
mounting nut, as outlined in Figure 5.