Kambrook STEAMLINE KI730 - Manual (Page 11)

11
To ensure your iron maintains optimum
performance it is recommended that it
be cleaned using the Self-Clean function
to remove scale or impurities.
• Set the steam selector to the
DRY position.
• Fill the water tank up to the maximum
level (MAX) with the water cup
supplied.
• Set the Temperature Control to MAX
(Linen) setting.
• Place the iron in the upright position,
insert the plug into the power outlet
and switch the iron on.
• Allow the iron to heat until the heating
indicator light turns off.
• Switch the iron off at the power outlet
and remove the plug.
• Hold the iron horizontally over the sink.
• Press and hold the SELF CLEAN button.
• Water will drip through the holes in the
soleplate. Move iron until all water has
dripped out of the water tank.
NOTE: Once you have used the
Self-Clean function, it is normal
for some water to remain in the
water tank. This is due to the
Anti-Drip System preventing
the tank from being emptied
completely. This will not affect the
performance of the iron.
Repeat the Self Clean process if the iron
still contains a lot of impurities.
Care and Cleaning
CAuTION: Only push and
hold the Self-Clean button
when you want to activate
the self cleaning function.
Do not push and hold
whilst ironing.
Boiling water and steam
will drip from the holes in
the soleplate during the
cleaning process. Due
caution and attention
should be exercised.
Cleaning the Soleplate
and Exterior
Ensure that the iron is disconnected from
the power outlet.
To remove residue which may have built
up from certain fabric finishes, clean the
soleplate with a rough cloth that has
been soaked in a vinegar and water
solution. Dry thoroughly with a soft cloth.
To clean the steam holes, simply use a
damp cloth to wipe away build up of lint
or starch from inside the steam holes.
Wipe the outer housing with a soft, damp
clean cloth and polish with a dry cloth.
NOTE: Never use abrasives
or scouring pads to clean the
soleplate. Avoid hard contact
with metal objects. Do not
scratch or damage the surface of
the soleplate.
Do not use harsh or abrasive
cleaners as they may damage
the surface of the iron. Never
immerse the iron in water or any
other liquid.
KI730_KI760_KI780_IB_D12.indd 11 5/12/12 11:53 AM