Knoll Systems HT201 - Manual (Page 5)

Remote Control
Inserting the
batteries
1) Press firmly and
slide the battery
cover off.
2) Insert the
supplied two
batteries (size
AAA). Ensure
that the polarities
(+ and -) of the
batteries are
aligned correctly.
Always replace
batteries with
fresh alkaline
type.
3) Slip the cover
back over the
batteries until it
snaps into place.
Notes
• If the remote
control gets wet,
wipe it dry
immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the batteries.
• Do not mix new and old or different types of batteries.
• There are operations that can only be carried out by remote control. Handle the remote control
carefully.
Remote control effective range
Each side of the projector has a remote sensor. The controllable range is 50 degrees horizontally
and 30 degrees vertically relative to a line that is at a right angle to the remote sensor. And the
distance between the point of the remote control and remote sensor must be no more than four to
five meters (about 15’).
.
5