Kawasaki 840138-1HR User Manual

Page 19

Equipment service must be performed only by qualified repair personnel using
authorized replacement parts. Service or maintenance by unqualified personnel
could result in considerable risk of personal injury. Use of unauthorized parts or
failure to follow maintenance instructions may create a risk of electric shock or
injury.

ACCESSORIES

Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.

Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.

If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may
experience a loss of power, excessive voltage drop or overheating. The smaller the
gauge number, the heavier the cord (see table below).

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS

TOOL CURRENT RATING

CONDUCTOR SIZE IN A.W.G

AMPERE

10FT.

25FT.

50FT.

100FT.

3-6

6-8

8-10

10-12

12-16

16-20

SPECIFICATIONS

Voltage

19.2V

Light Bulb Type

Krypton 18V 0.3A

Charger Input

120V

60Hz

Charging Time

Approx. 1 Hour

Battery Type

Ni-Cad

For your convenience, a spare light bulb is included

inside the unit. Unscrew the rim and carefully remove it from the light
assembly.

1. Remove the battery pack from the

Worklight.

2. Hold the top of the Worklight with

one hand while twisting the rim in a
counter-clockwise direction with the
other. Continue turning until the rim
comes loose.

3. Remove the bulb by turning it

slightly and pulling it out of the bulb
fitting. Be careful not to damage the
delicate parts inside the case.

4. Insert the new bulb, then carefully

put the rim back in place and turn
it clockwise to tighten it.

MAINTENANCE AND CLEANING

Always remove the battery pack before attempting

cleaning or maintenance.

Use only mild soap and a damp cloth to clean the tool. Never let any liquid get
inside the casing. Never immerse any part of the tool in a liquid. Always keep the
ventilation openings clear.

Always clean the battery pack using only a dry cloth. Do not use liquids.

Always unplug the charger before cleaning it.

Regularly clean the ventilation slots in your tool and charger using only a soft
brush or dry cloth.

Never open the Worklight case, battery pack or charger. Do not attempt to repair
the Worklight, battery pack or charger yourself. Opening any of these parts will void
your warranty.

Use only authorized replacement parts for your tool.

REPLACEMENT

BULB