Snapper 2730 - Manual

PARTS LIST
Mounted on
deck.
hardware for,
48” mower.
NOTE
Deflector brace (F, figure 1) and adaptor hold-
down (R) are preassembled to adaptor
with
rivets (G).
Figure
Ref. Description Part No.
A 1 Nut, 8 1816950
8 1 Lockwasher. 1916965
c 1 Washer, 1919384
D 1 Spacer 153081
E 1 Bolt, Carriage, 6 1 1917378
(42”)
1 Bolt, Carriage. 3/8-16x 1923220
(48”)
F 1 Deflector Brace 1700260
G 6 Rivet 928706
H 1 Nut, 1960251
I 1 Washer, 960027
J 1 Bolt. Carriage, 1931349
K 1 Spring Latch 1678786
L 1 Nut. 1917372
M 1 Lockwasher, 6 1917356
N 1 Washer. 6 1917642
0 Adaptor Assembly G and
1 42” 1678667
1 48” 1678668
P 1 Washer. 1817378
cl 1 Carraige, 1 1931335
1 Adaptor 1679548
INSTALLATION
INSTRUCTIONS
MFG. NO. 1691170 FOR 42”MOWERS
MFG. NO. 1691009 1691182
MFG. NO. 1691171 FOR 48” MOWERS
MFG. NO. 1690986 1691193
A
WARNING
The adapter is part of the collector system.
Do not operate unless the adapter and entire
collector installed. If vacuum collector
is removed, the adapter and be sure mower
deflector is In original position.
A
WARNING
Shut off tractor engine and key before
installing or removing the adapter.
1. Refer to I to take inventory of required parts.
2. Attach the latch (K, 1) to
18 1 carriage bolt 16 I washer (P), 16
washer (N), 16 lockwasher (M) and 16 nut
3. Install the spacer with hardware shown,
in hole (A, figure 2) in mower deck. Remove existing
hardware. For the 42” adapter, use a
1
carriage bolt. For
carriage bolt. For the 42” adapter, use a 8 washer (B,
lockwasher (M) and nut (N)
supplied. For the 48” mower, use existing washer and
nut and the
washer (B) supplied.
Figure 2.
A. Install Spacer
8.
C. Stone Guard
1 6 7 9 2 7 2
IN U.S.A.
878