Star Trac Spinning Bike Computer - Manual (Page 14)

11
Time required:
•
15 Minutes
Parts required:
•
727-0083 Spinning® Computer Kit
NOTE: The thick insert is used on the V bikes
Tools required:
•
M5 Allen Wrench
•
M2 Allen Wrench
4.
Place the thick insert inside the bottom part of the Mounting Bracket
Clamp. Then position the mounting bracket onto the center-curved
portion of the handlebars. Once positioned correctly, tighten the 4 M6x20
screws using the M5 Allen tool.
5.
Install the computer onto the mounting bracket by sliding the computer clamp
over the long portion of the bracket. Tighten computer clamp with the M6 screw
and nut using the M5 Allen tool.
Installation Procedure V Bikes