Sharp AL-1551 - Manual (Page 35)

33
5
Supplies and user maintenance
USER MAINTENANCE
Transfer charger
If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the charger
using the following procedure.
1
Turn the power switch off.
2
Ensure that the bypass tray is open and then open the side cover while pressing the
side cover open button.
3
Take the charger cleaner out by holding the tab.
Set the charger cleaner onto the right end of the transfer charger, gently slide the
cleaner to the left end, and then remove it. Repeat this operation two or three times.
Slide the charger cleaner from the right end to the left end along the groove of
the transfer charger. If the cleaner is stopped on the way, smudges on copies
may occur.
4
Return the charger cleaner to its original position. Close the side cover by pressing
the round projections near the side cover open button.
5
Turn the power switch on.