SPT SP-5016 - Manual (Page 7)

13 12
Cleaning with Citric Acid. Replacing Worn Parts
Lid and Body
• Wipe clean with damp cloth.
Power Cord
• Wipe clean with dry, soft cloth.
Filter (located on bottom of inner tank)
• Remove and clean with soft brush
and lukewarm water.
• If extremely dirty, use Citric Acid.
• Ensure filter is properly re-installed
before operation.
Storage
When planning not to use for a
period of time, clean unit and
allow unit to dry completely.
Place unit back in original box
or cover with clean cloth and
store in a cool, dry place.
When cleaning with Citric Acid, all normal functions cannot be
operated.
1. Make sure filter is
installed.
2. Add approx. 1 oz
of Citric Acid.
3. Add water to the
FULL line.
4. Close lid.
5. Connect power.
6. Press and hold
REBOIL button for 3
seconds.
7. When done, the 3
temp lights stay on
continuously.
During cleaning process,
the 3 temp indicators
light in turn.
Be extra cautious
of steam and vapor
during cleaning process.
8. Press DISPENSE
button to remove
as much water as
possible.
9. Disconnect power.
10. Wait for unit to
cool, remove lid
and dump out
water.
11. Wash the interior
with clean sponge
and rinse clean.
Repeat above process if excessively dirty.
The rubber gasket on the lid will wear over time and will need to be
replaced periodically. Contact Sunpentown (
www.spt-usa.com / 909-
468-5288 ) to purchase replacement gaskets or for instruction to send
in for repair.
Instructions on replacing the gasket:
1. Remove lid.
2. Loosen the 3 screws and remove inner lid. Do not lose the screws.
3. Remove old rubber gasket.
4. Insert new gasket according to image below.
5. Replace inner lid and tighten the screws.
Screw
Rubber
gasket
INNER LID
OUTER LID
Power cord: should the power cord become damaged, it must be
replaced by Sunpentown. Do not substitute with other power cords.