Swisher LS934 - Manual (Page 13)

Optional Extended Table For Log Splitter Kit No 7490
This table is designed to fit both the Standard and the Deluxe Swisher Log Splitter. The Standard
attachment slips over the beam pivot tube and attaches with the hitch pin through the vertical beam lock
hole. The attachment to the Deluxe Splitter requires the use of two Table Clamps (2). These clamps
tighten over the lower flange of the “I-Beam”
Assembly instructions
Set Table Support (1) on flat surface, install two Table Risers (5) with four Flange Bolts (8) and four Flange
Nuts (7) each. Attach Tables (4) and (3) to the top of the Table Risers (5) with two Carriage Bolts (6) and
two Flange Nuts (7) each.
If installing on the Deluxe Splitter attach one Table Clamp (2) in the NON-slotted set of holes (finger tight).
Attach with three Flange Bolts (8) and three Flange Nuts (7). Slip table assembly onto lower flange of
beam and draw toward seating tightly. Install second Table Clamp (2) locking to beam. Finish the
assembly by tightening all fasteners securely with wrenches.
Caution- Do not over load table allowing hitch to rise. Always block tires before using.
No. 7170 Rev.