SOYO G668 - Manual (Page 13)

SOYO G668 Ethernet IP Phone User Guide
11
Configuration via IP Phone Keypad
Configuration for DHCP (default)
The SOYO-G668’s default setting is set on DHCP enabled. If you have a router
with DHCP support, or if you connect the IP phone directly to the cable modem
with dynamic IP address from the ISP, you don’t need to perform any of the
following configurations.
If you are using PPPoE or static IP, you will need to follow the instructions
below to setup the phone. Please make sure the IP phone is powered on and
all the cables are securely connected before performing the following:
Entering Configuration Mode
Go to the dial pad and press “Hand-free Speaker” (or picking up the handset)
and enter 1234 (the default code), and press the “#” button until the screen
display read “Password” then enter 1234 again, press “Hand-free Speaker”.
“Network Settings” will be displayed on the LCD screen. You have entered the
“Network Settings” menu and you are ready to configure your IP Phone.
This is a list of functions corresponding to the “keys”.
Keys Function
Local IP
Enter change mode to change parameter
Speaker
Enter Sub-menu, confirm changes
Redial
Exit current manual, exit change mode
Volume+
Turn over manual backward
Volume-
Turn over manual forward, move cursor back in change mode
Number Keys
Modify parameters
Note: Press “#” to shift between upper and lower case.