Sharp R-190HK/HW User Manual

Page 16

SEC R-190H

TINSEA975WRRZ-D32 SEC R-190H

Disconnect the power cord before cleaning or
leave the door open to inactivate the oven dur-
ing cleaning.

Exterior

The outside surface is painted. Clean the outside with
mild soap and water; rinse and dry with a soft cloth. Do
not use any type of household or abrasive cleaner.

Door

Wipe the window on both sides with a damp cloth to
remove any spills or spatters. Metal parts will be easier
to maintain if wiped frequently with a damp cloth. Avoid
the use of spray and other harsh cleaners as they may
stain, streak or dull the door surface.

Touch Control Panel

Wipe the panel with a cloth dampened slightly with water
only. Dry with a soft cloth. Do not scrub or use any sort
of chemical cleaners. Close door and touch STOP/
CLEAR pad.

Interior

Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe
with a soft cloth and warm water. DO NOT USE ABRA-
SIVE OR HARSH CLEANERS OR SCOURING PADS. For
heavier soil, use baking soda or a mild soap; rinse thor-
oughly with hot water. NEVER SPRAY OVEN CLEANERS
DIRECTLY ONTO ANY PART OF THE OVEN.

Waveguide Cover

The waveguide cover is made from mica so requires
special care. Keep the waveguide cover clean to as-
sure good oven performance. Carefully wipe with a
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch fire.
Do not remove the waveguide cover.

Odor Removal

Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.

Turntable / Turntable Support

The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and a non-abra-
sive scouring sponge. They are also dishwasher-proof.
The turntable motor shaft is not sealed, so excess wa-
ter or spills should be wiped up immediately.

C L E A N I N G A N D C A R E

Exterior

Interior

Turntable

Turntable Support