Sharp TINSE4796FCZZ - Manual (Page 6)

4
CAUTIONS
Installation notes
CAUTION
Do not install in a location with moisture or
dust.
Risk of fire and electrical shock.
If dust enters the machine, dirty
output and machine failure may
result.
Locations that are excessively hot, cold,
humid, or dry (near heaters, humidifiers, air
conditioners, etc.)
The paper will become damp and condensation
may form inside the machine, causing misfeeds
and dirty output.
☞
Ambient environment (page 43)
If the location has an ultrasonic humidifier, use
pure water for humidifiers in the humidifier. If tap
water is used, minerals and other impurities will be
emitted, causing impurities to collect on the inside
of the machine and create dirty output.
Do not install the machine on an unstable or
slanted surface. Install the machine on a
surface that can withstand the weight of the
machine.
Risk of injury due to the machine falling or
toppling. If peripheral devices are to be installed,
do not install on an uneven floor, slanted surface,
or otherwise unstable surface. Danger of slippage,
falling, and toppling. Install the product on a flat,
stable surface that can withstand the weight of the
product. (Weight when various peripheral devices
are installed: approx. 136.7 lbs. (62 kg))
Installing the machine next to
a diazo copy machine may
cause dirty output.
Locations with ammonia gas
Do not install the machine in a location with
poor ventilation. Install so that exhaust from
the machine does not directly contact people.
A small amount of ozone is created inside the
machine during printing. The amount of ozone
created is not sufficient to be harmful; however, an
unpleasant odor may be noticed during large copy
runs, and thus the machine should be installed in
a room with a ventilation fan or windows that
provide sufficient air circulation. (The odor may
occasionally cause headaches.)
* Install the machine so that people are not directly
exposed to exhaust from the machine. If installed
near a window, ensure that the machine is not
exposed to direct sunlight.
Locations exposed to
direct sunlight
Plastic parts may
become deformed
and dirty output
may result.
mxc402_us_sta.fm Page 4 Thursday, June 17, 2010 11:20 AM