Sony CMT-CQ1 - Manual (Page 9)

T
une
r
9 GB
5
Press ENTER.
6
Repeat steps 1 through 5 to preset
other stations.
Tip
Press TUNING MODE to stop scanning.
Manual tuning preset
You can manually tune in and store the radio
frequency of the desired stations.
1
Press TUNER BAND repeatedly to
select FM or AM.
2
Press TUNING MODE repeatedly until
“AUTO” and the preset number
disappear from the display.
3
Press TUNING +/– repeatedly to tune in
the desired station.
4
Press TUNER MEMORY.
The preset number flashes. The stations are
stored from preset number 1.
5
Press ENTER.
6
Repeat steps 1 through 5 to preset
other stations.
Other Operations
To improve tuner reception
When tuner reception is poor, set CD player
power off by the CD power manage function.
CD power is factory set to on.
1
Press FUNCTION repeatedly to switch the
function to CD.
2
Press ?/1 to turn off the system.
3
Press ?/1 while holding x.
“CD POWER OFF” appears.
To set the CD power on
Repeat the procedure above and “CD POWER
ON” appears.
Note
When “CD POWER OFF” is selected, CD access time
is increased.
To change the AM tuning interval
(except for European and Middle
Eastern models)
The AM tuning interval is factory-preset to 9
kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding >,
press ?/1. When you change the interval, all the
AM preset stations are erased. To reset the
interval, tune in any AM station first, then turn
off the system. While holding >, press ?/1.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
To Do this
Tune in a station
with a weak signal Follow the procedure described
in “Manual tuning preset”
(page 9).
Set another station
to the existing
preset number After step 4, press TUNING +/–
repeatedly to select the preset
number you want to store the
station and then press ENTER.