SIIG 04-0192A - Manual (Page 2)

2
Hardware Installation
General instructions for installing the card are provided below, since
the design of computer cases and motherboards vary. Refer to your
computer’s reference manual for further information, if needed.
Static Electricity Discharge may permanently damage your system.
Discharge any static electricity build up in your body by touching
your computer’s case for a few seconds. Avoid any contact with
internal parts and handle cards only by their external edges.
1. Turn OFF the power to your computer and any other connected
peripheral devices. Unplug the computer's power cord.
2. Remove your computer’s cover and install the card in an
available PCI slot.
3. Push the board down firmly, but gently, until it is well seated.
4. Secure the card and replace the cover.
Software Installation
Windows 98/98 SE:
Windows 98/98 SE will automatically detect the presence of the
Low Profile USB Adapter. Follow the procedures below to install the
host adapter drivers:
1. At the Add New Hardware Wizard, click Next.
2. Choose Search for the best driver for your device
(Recommended) and click Next.
3. Insert Windows 98 CD-ROM and check CD-ROM check box.
4. Click Next, Next, and Finish to complete driver installation.
Windows ME/2000:
Windows ME and Windows 2000 will automatically detect and
install the correct driver for this adapter. No installation is needed.