Sony MPEG4 Video Recorder - Manual (Page 52)

48
Figure 1 Main Page
Note: Depending on your region, you may need to change TV out-
put from NTSC to PAL at this point. This is done by accessing the
settings menu (figure 2 below) and changing the TV Output mode.
(4) Upgrade the firmware
• Unzip and Save new firmware file to CF/Memory stick card via a
CF/Memory stick card reader. The vcr4800.bin file should be
saved directly to directory and not in any folder.
• Insert CF/Memory Stick card into the MPEG-4 recorder.
• Scroll to the Setup mode by pressing right arrows on the remote
controller. Setup mode shows as the figure 2.
Figure 2 Setup Menu
• Press “Enter” on the remote controller entering the Setup menu.
• Scroll through the Setup menu to the second page. The current
firmware version like v.1.03.44 will show underneath the Factory
Reset.
• Use the up arrow to scroll to the Firmware Upgrade.
• When the Firmware Upgrade is highlighted, press “Enter” on the
remote controller to start the firmware upgrade.
• A “Clock” icon will pop up and remains for seconds.
MPEG-4 Video Recorder_UM_EN.book Page 48 Thursday, June 22, 2006 2:14 PM