Philips Saeco INCANTO SUP021R - Manual (Page 14)

14
The control panel and indicator lights will assist you with the functioning and
maintenance of the unit.
Descale the machine
Fill the water tank with fresh water.
Prime the machine
Fill the coffee bean container with coffee
beans and press the desired coffee button
to start the brewing cycle.
Open the door, remove the dregs drawer
and empty the used coffee grounds.
Important note: the dregs drawer may
be emptied only when the machine is
ON. The drawer must be removed for at
least 5 seconds for the machine to read
that the drawer has been emptied. If
you empty the drawer with the machine
off, you will not be able to dispense
coffee the next time you switch the
machine on.
Put the brew group, drip tray and dregs
drawer correctly into place.
Close the front door.
Coffee grinder motor jammed.
Brew group motor jammed.
Contact an Authorized Service Center.
Flashing
Steadily lit
Flashing
Steadily lit
Flashing
Steadily lit
Flashing
DISPLAY MESSAGES
PROBLEMS CAUSES REMEDIES
The brewing cycle
does not start.
No coffee beans. Refill bean hopper and press
desired coffee button.
No water. Fill water tank. Message will
clear.
Dredge drawer / waste
box is full.
Remove waste box while
machine is on. Leave out for
5-10 seconds and put back in
machine. Message will clear.
Brew group missing. Remove drip tray, waste box
and brew group. Put brew
group back in machine until
securely locks in place, put
waste box and drip tray back
in and shut service door.
Coffee flows too
quickly.
Grind is too coarse. Adjust the grinder to a finer
grind, ex. from 5 to 3. Adjust
only while grinder is grinding
and only a maximum of 2
settings at a time. It will take
3-4 cups to see results.
Dose needs to be increa-
sed.
Turn doser towards + sign.
Coffee flows too
slowly.
Grind is too fine. Adjust the grinder to a coarser
grind, ex. from 5 to 7. Adjust
only while grinder is grinding
and only a maximum of 2
settings at a time. It will take
3-4 cups to see results.
Dose needs to be decrea-
sed.
Turn doser towards - sign.
Filter screen in brew group
is clogged.
Clean the filter screen using
the key provided.