Assembly, Remove generator from carton, Tools needed for assembly – Sears Companion 919.329110 User Manual
Page 9: Carton contents
9 — ENG
D20508
Read owner’s manual. Do not attempt to operate equipment until you have read Owner’s
Manual for Safety, Assembly, Operation, Maintenance, Storage Instructions.
REMOVE GENERATOR FROM CARTON
•
Open carton from top.
•
Cut carton along dotted lines.
•
Remove all carton inserts.
•
Remove generator through opening in carton.
•
Using a 9/16 inch socket remove shipping block
from under the generator head. Unscrew the bolt
and remove the wood block. NOTE: It is very
important that this is removed before starting your
generator.
ASSEMBLY
TOOLS NEEDED FOR ASSEMBLY
1- Box Cutter or Knife
2 - 9/16 " Wrenches
2 - 1/2" Wrenches
1 - 1" thick x 1' square piece of wood
IMPORTANT: Before any attempt to start your genera-
tor be sure to check engine oil (See Adding Engine Oil
paragraph in the Operation section on page 13 of this
manual.)
CARTON CONTENTS
1 - Handle
1 - Generator
2 - Wheels
2 - Handle Caps
1 - Foot Bracket
2 - Bracket
1 - Isolator Foot
2 - 5/16-18 x 1 3/4 "
Cap Screws
2 - Shoulder
Bolts
2 - 3/8-16
Lock Nuts
2 - Washers
4 - 5/16-18 x 3/4 "
Cap Screws
7 - 5/16-18
Lock Nuts
1 - Owner's Manual
*1 - Twistlock
Plug L14-30P
*
To be installed and/or used in
accordance with appropriate local electrical codes
and regulations. Refer to enclosed instructions for
proper installation.
1 - Parts Bag
1 - Parts Box
1 - Bottle of oil