Smeg 129316 - Manual (Page 19)

129316
Interferences from the ambient (for example
electrical wiring) could induce signalization of
different faults. In such cases:
- switch the appliance off, and wait for a few
seconds;
- plug in the appliance and repeat the drying
program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to
interferences from the environment (lightning stroke,
power supply circuit faults, natural disasters).
19
Trouble Check
Appliance does not
work:
• If there is current in the socket and if the fuse is
functioning.
• If the plug is correctly inserted into the socket.
There is current in the
socket, but the drum is
not rolling:
• If the door is closed tightly (press it towards the
appliance).
• If the program runs according to instructions.
• If the container is full (only with condensation
dryer),
• If appropriate drying time is selected.
Laundry is not dry: • If the fi lter is clean.
• If the condensation device is clean (only with
condensation dryer).
• If the room is adequately ventilated.
• If the amount of laundry to be dried is not too big.
• If the evacuation tube is too long (only with
evacuation dryer - max 2 m).
• If the laundry loaded in the drum has not been
spun enough or if appropriate drying time has been
set.
• If the room is too hot (over 25°C, applies for
condensation dryer).
The condensation is
inadequate:
• If the room temperature is too high.
• If the condensation device is clean.
Troubles