Sony PCS-11 - Manual (Page 40)

GB 18
System Connections
System Connections
This section describes the typical system connections.
• Be sure to turn off all the equipment before making any connections.
• Do not connect/disconnect the camera cable with the power on. Doing so may damage
the Camera Unit or Communication Terminal.
• For safety, do not connect the 100BASE-TX/10BASE-T connector to a network that
applies an excess voltage via the 100BASE-TX/10BASE-T connector.
Notes
System Connection via a LAN
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN–AUX2 CAMERA UNIT MIC
(PLUG IN POWER) ISDN UNIT
(MIXED)
AUX MAIN– MONITOR– SUB
VIDEO OUT
IR OUT
100BASE-TX
10BASE-T
1 2
1 2
TERMINAL VISCA OUT
PCS-C11/C11P Camera Unit
to TERMINAL
PCS-P11/P11P
Communication
Terminal
Camera cable*
Audio
connecting
cable*
S-video
connecting
cable*
Power cord*
to CAMERA UNIT
to AUDIO
OUT
to VIDEO
OUT
MONITOR
MAIN
to S-video
input
to audio input
to 100BASE-TX/
10BASE-T
to LAN
TV monitor**
to a wall outlet
to DC19.5V
PCS-AC195
AC adaptor
to a wall outlet
* supplied
** not supplied
UTP cable (category 5, straight)**