Sony BRAVIA KDL-26S2010 - Manual (Page 43)

Other Information
43
Other Information
Preparation for Wall Mounting the KDL-23S2010, KDL-26S2010 and KDL-32S2010
This TV can be installed on a wall by using a wall-mount bracket (sold
separately). Before mounting the TV on a wall, the Table-Top Stand must be
removed from the TV.
Follow the simple steps below to remove the Table-Top Stand:
1 Disconnect all the cables from the TV.
2 Cover a level and stable surface with a thick and soft cloth.
3 Gently lay the TV, face down, onto the cloth. Make sure the Table-Top
Stand is hanging over the edge.
4 Rotate the cable holder 90 degrees, and pull it out completely. [See
illustration A]
5 Remove the screws and detach the Table-Top Stand from the TV. [See
illustration B] Be sure to hold the Table-Top Stand firmly while
removing the last screw.
6 Do not remove any other screws from the TV.
For bracket installation, refer to the instruction guide provided by the Wall-
Mount Bracket model for your TV. Sufficient expertise is required in
installing this TV, especially to determine the strength of the wall for
withstanding the TV’s weight. For product protection and safety reasons,
Sony strongly recommends that you use the Wall-Mount Bracket model
designed for your TV and the wall-mounting of your TV should be
performed by Sony dealers or licensed contractors.
Do not remove the Table-Top Stand for any reason other than to wall-
mount the TV.
Be sure to store the removed screws and Table-Top Stand in a safe
place until you are ready to reattach the Table-Top Stand. Keep the
screws away from small children.
Sony Wall-Mount
Bracket Model
SU-WL31
(KDL-23S2010/
KDL-26S2010/
KDL-32S2010)