Stanton DIGIPAK SINGLE TOP LOADING CD PLAYER PROFESSIONAL PREAMP MIXER - Manual (Page 7)

SMX-211 MIXER FEATURES
TOP & FRONT PANEL
1. Input fader - Controls individual source levels (channels)
in the mix.
2. Input toggle switch - Selects which source will be active
based on what you have connected to the rear panel
input section (phono/line).
3. Treble and Bass EQ - Adjusts the high and low
frequency levels of the input channels for good sound.
4. Channel Gain - Adjusts the pre-fader volume for cleaner
sound.
5. Replaceable Crossfader - Achieves clean segues
between the two input channels. "Hard left" selects
Channel 1. "Hard right" selects Channel 2. With the
crossfader centered, both assigned channels are live.
Use the crossfader for fast and seamless segues (fades)
from one selected channel to the other.
Note: The crossfader is user replaceable in case of
failure. Simply unscrew the two large screws which hold
it in place, lift it out and disconnect itís cable. Re-attach
the new crossfader and screw the mounting plate back
onto the unit - youíre back in business!
6. Mic Input Gain - Adjust s microphone input level.
7. Mic Input - Insert your Micr ophone with 1/4 plug in here.
8. Headphone Input - Insert in the 1/4 plug for your
headphones here.
9. Channel Cue / Cue Pan - Used to preview channel
audio to your headphones. Listen here before bringing
up channel faders or moving the crossfader.
10. Headphone Level ñ Adjusts cue volume.
11. Master Fader - Controls the overall output level.
r.
REAR PANEL
12. Grounding post - for turntable connection. Always use
this connection when using standard turntables with
ground cable. (Some turntables like the STR8-80 /100
do not require grounding wire).
13. Phono Inputs - Plug your turnt ables in here. When these
connectors are used, your signal is fed directly to the
high-quality RIAA phono pre-amplifiers. Use this position
only for turntables. Line level sources will overload the
sensitive phono pre-amps and will cause distortion.
14. Line Inputs - Unbalanced RCA jacks for connecting
stereo audio from line level sources such as CD players,
HiFi VCRs, cassette and reel-to-reel tape decks, DAT
machines, laser discs, tuners, even synthesizers or
other mixing consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a "Y" cable connecto
15. Stereo Main Outputs - Unbalanced RCA connectors
controlled by the Master fader.
16. Fader Start - This function works in conjunction with a
compatible fader start CD player. When used with a
compatible CD player, you can use the crossfader to
start and stop the CD player with the slide of the fader.
The fader start switch activates the fader start feature.
When in the ON position, the fader start allows the fader
to return automatically to preset digital CUE POINTS on
your compatible STANTON DJ CD Player.
17. Power Connector - Plug in power adapter here and
check the voltage level to match your countryís
standard.
18. Power Switch - turns unit off and on. Note*** Remember
to turn ALL volume levels down when turning on/off the
unit.
18 17 15 14 13 12 16