Siemens 9000407137(8811) - Manual (Page 20)

en
20
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
First disconnect the appliance from the
power supply.
Remove the filters
27 .
Scoop out water, use a sponge
if required.
Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and first pull it
upwards until it resists and then pull
it out forwards.
Check inner compartment and remove
any foreign objects.
Place cover in the original position,
press down and engage.
Install filters.
Troubleshooting
Experience has shown that you can rectify
most faults which occur in daily operation
without calling customer service.
Obviously this will save on costs and
ensure that the machine is quickly
available again. The following overview
should help you locate the causes of faults
which may occur.
Warning
If an error code (E:01 to E:30) is indicated
on the digital display
3 , always
disconnect the appliance from the power
supply and then turn off the tap.
You can rectify certain faults yourself
(see following fault description), for all
other faults please contact customer
service and state the indicated fault E:XX.
Warning
Remember: Repairs may be carried out by
technicians only. If a component has to be
replaced, ensure that only original spare
parts are used. Improper repairs or use
of non-original spare parts may cause
considerable damage and put the user
at considerable risk.
... when the appliance is
switched on
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been
inserted.
The appliance door has not been
shut properly.
... on the appliance
Lower spray arm rotates sluggishly.
Spray arm blocked.
The door is difficult to open. *
Child-proof lock is activated.
The deactivation instructions are
at the back in the envelope.
* depending on model