Fixing the kitchen radio beneath a wall cabinet, Setting up the kitchen radio – Silvercrest KH 2289 User Manual
Page 7
- 5 -
Fixing the kitchen radio beneath
a wall cabinet
With the supplied mounting plate
q
you can fix
the kitchen radio below, for example, a kitchen wall
cabinet:
1.
Determine a suitable location for the kitchen
radio.
2.
Press the two retaining levers on the back of
the appliance down. Push the mounting plate
q
back and remove it.
3.
Place the mounting plate
q
against the instal-
lation location. Allow 3,5 cm room to the front
edges. This way the kitchen radio will later
fit flush.
4.
Mark the four points for the drillholes with a
pencil.
5.
Mark the drillhole with a mandril.
6.
Firmly secure the mounting plate
q
with the
supplied screws.
7.
Place the kitchen radio diagonally with the two
recesses in the retainer lugs of the mounting
plate
q
. Press the kitchen radio up until you
hear it engage.
Note:
Secure the wire antenna with a piece of adhesive
tape such that it does not hang down.
Disassembly
• To disassemble the kitchen radio, press the two
retaining levers at the rear of the appliance
downwards. Then pull the kitchen radio forewards
to remove it.
• Unscrew the screws and dismantle the mounting
plate.
Note:
Replace the mounting plate onto the radio as
described in the following section.
Setting up the kitchen radio
Do not set up the kitchen radio without the mounting
plate
q
. Otherwise the speakers are covered and
the sound is scarcely audible.
To set up the kitchen radio with the enclosed
mounting plate
q
:
1.
Simultaneously press the two retaining levers
on the back of the appliance down. Push the
mounting plate
q
back and remove it.
2.
Push the two retainer lugs on the mounting
plate
q
into the recesses on the lower rear
side of the kitchen radio.
3.
Firmly press the front part of the mounting plate
q
down until you hear it engage. You can now
set up the radio.
To disassemble the mounting plate
q
, grip the
mounting plate
q
from below with the thumbs and
press it forwards and up until it disengages. You can
now remove the mounting plate
q
.
IB_KH2289_DT33485_LB6.qxd 18.06.2009 12:16 Uhr Seite 5