SOYO Super 7 SY-5EMA - Manual (Page 13)

SY-5EMA+ V1.x Quick Start Guide
13
Installation
Step 4.
Attach Connectors
This section tells how to connect internal peripherals and power supply to the Motherboard.
Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Front Panel
Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock Switch.),
Wake-On-LAN card, VGA card, Sound Card, and other devices.
For more details on how to connect internal and external peripherals to your new SY-5EMA+
V1.x Super 7 ™ Motherboard, please refer to SY-5EMA+ V1.x Motherboard User's Guide
and Technical Reference online manual on CD-ROM.
Connectors and Plug-ins
IrDA (Infrared Device Header): IR1 Wake-On-LAN Header: JP44
Pin1 Pin2 Pin3 Pin4 Pin5 Pin1 Pin2 Pin3
VCC None IRRX GND IRTX 5VSB GND MP-Wakeup
CPU Cooling Fan: CPUFAN Chassis Cooling Fan: CHAFAN
USB
Pin1 Pin2 Pin3 Pin1 Pin2 Pin3
GND 12V NC GND 12V NC
Connect your USB devices
to this header.
Power LED Keylock
Pin1 Pin2 Pin3 Pin1 Pin2
5V NC GND Control Pin GND
Speaker
Pin1 Pin2 Pin3 Pin4
5V NC NC Speaker out
HDD LED
TB LED
PWRBT RESET
Pin1 Pin2 Pin1 Pin2 Pin1 Pin2 Pin1 Pin2
LED Anode LED Cathode LED Anode LED Cathode Power On/Off GND Power Good GND
ATX Power On/Off: PWRBT
Connect your power switch to this header (momentary switch type).
To turn off the system, please press this switch and hold down for longer than 4 seconds.
ATX Power Supply: ATX PW
Attach the ATX Power cable to this connector.
Please make sure the ATX power supply can take at least 720mA load on the 5V standby lead (5VSB), if you
want to use the advanced power management functions like Power-On by modem or WOL.
Power LED Key Lock Speaker
Reset PWRBT Turbo LED HDD LED
+ +
+ +
_ _
_ _