Sanitaire S107 - Manual (Page 6)

Cleaning and Replacing Dust Cup Filter, PN 62406
Pull fi lter off of fi lter frame.
Shake and brush the dust and dirt from fi lter. If desired, launder fi lter by
by
hand in warm water using a mild detergent.
NOTE: Air dry thoroughly before returning to use.
To put fi lter on fi lter frame, pull and stretch the elastic edge of fi lter up and
over the rim on the fi lter frame.
How To Maintain
The instructions in this booklet serve as a guide to routine maintenance. To keep the cleaner operating at top effi ciency empty
the dust cup and clean the fi lter after each use.
Empty Dust Cup
CAUTION: Turn off the switch and unplug the electrical cord before servicing.
1. Remove hand vac from the base unit. 2. Push in on dust cup latch
and pull dust cup from
handle section.
3. Remove dust cup fi lter from dust
cup. Shake and brush the dust and
dirt from fi lter.
Dust
Cup
Latch
4. Shake contents of dust cup into a
waste container.
5. Replace dry dust cup filter in dust
cup and reassemble following above
directions in reverse.
NOTE: Replace a dirty or torn fi lter.
6. Dust cup may be cleaned with warm
water and mild detergent. Wipe dry, do
not put dust cup in dishwasher.
Clean Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush
roll free from hair and threads so it will continue cleaning.
Elastic
Edge
Filter
Frame
Rim
Correct Installation Correct Installation
NOTE: If fi lter is not properly installed, dirt and dust will go past the
fi lter and this can damage the cleaner motor.
6