Traction drive group – Simplicity 1694434 User Manual
Page 22
Traction Drive Group
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
Apply loctite to
screws and torque
to 55 - 60 in-lbs
(2 places).
Pack groove
with grease.
Apply locktite and
torque to 8 - 10 ft. lbs.
Retainer to be
loacted inside frame.
Tighten when all parts are
tight against shoulder of hub.
Maximum gap between Ref 19
and 22 when assembled .005" - .007".
Torque to
10 - 14 ft-lbs.
Retainer to be
loacted inside frame.
Coat with
synthetic 5W-50
motor oil.
Apply anti-seize
to both ends.
Bell crank must
pivot freely.
Earred end
With hub (Ref. 32) away from pivot arm
assembly (Ref. 35), tighten so that drive disk
(Ref. 39) has no play, but is still free rotate.
Torque to
10 - 14 ft-lbs.
Remove all play out of axle by
moving axle to left, move set
collar (Ref. 27) to the right to
take all play out of sprocket
assembly (Ref. 29) and tighten.
Befiore making this adjustment
be sure tie bar support (see Frame Group)
Is installed between frame sides.
Apply loctite
(2 places).
1
2
3
4
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
10
11
5
12
13
9
27
28
29
30
31
32
33
34
35
36
38
39
40
41
42
43
44
45
46
28
41
12
13
19
37
47
SC984936
The above parts group applies to the following Mfg. Nos.:
2003
22
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694433 - 860E
1694434 - 860M
TP 400-3889-00-LW-S