Sanyo CLT-D6614 - Manual (Page 30)

30
You have four handsets, therefore, you can enjoy an intercom call between
handsets. You can also establish a conference call (between two handsets and
outside).
Registration
The handset and base unit are factory pre-registered with each other. Handsets
are numbered 1 to 4. Therefore, the unit should be in full working order out of the
box.
If your handset is not registered to the base "NOT REGISTERED" will display on
the handset. The handset must first be registered to the base to be used.
To.register.a.new.handset:
1. Touch
and select the SECURITY SET menu and then the
REGISTRATION submenu.
2. Use
.or. .to select the base number you wish to register to.
3. Touch .to confirm.
4. Enter the 4 digit PIN code (default 0000) and touch , you will see the
message: 'REGISTERING'.
5. Press and hold the PAGE key on the base until the Charge/In use LED
flashes.
6. ‘REGISTRATION ACCEPTED’ indicates that handset is registered.
‘RETRY?’ indicates that registration has failed. Touch to retry or to
quit.
To.select.a.base.unit.on.your.handset:
Your telephone supports up to 4 base units. After you register 1 handset to 4
base units, bases are numbered 1 to 4, you may select which one to use.
1. Touch
and select the SECURITY SET menu and then the SELECT
BASE submenu.
2. Use
or to select the base number or ‘AUTO’ (automatically selects
the nearest base).
3. Touch
.to confirm.
4. ‘ACCEPTED’ indicates that base has been selected. ‘RETRY?’ indicates
that selection has failed. Touch
to retry or to quit.
MULTI.HANDSETS.FUNCTIONS