SpectraLink 8668 - Manual (Page 89)

75 Inter-Tel ® Model 8664/8665/8668 User Guide
MO
VING O
N
U
SING
A
CCOUNT
C
ODES
If your telephone system is programmed to use the Station Message Detail Recording
(SMDR) feature, you might be required to enter account codes when you place a call.
These codes add information to telephone record reports that the system will periodi-
cally print.
There are three types of account codes:
• Standard account codes are automatically entered into the SMDR report when-
ever you place a call.
• Forced account codes must be dialed before you can place an outside call.
• Optional account codes can be entered at any time during a call.
NOTE: Your system administrator can tell you which types of account codes are used
on your telephone system.
To enter an optional account code while on a call:
1. EITHER, Press - .
OR, Press until the Feat softkey is available and then press the Feat softkey.
2. Dial .
3. Dial the optional account code. If the account code is not immediately accepted,
press .
To set an account code for all calls placed from your endpoint:
1. While in idle mode, press to bring up the two-line display.
2. Dial and then the account code. If the account code is not imme-
diately accepted, press . This code will be used for all calls made from your
endpoint until it is disabled.
To disable the account code you set for your endpoint:
1. While in idle mode, press to bring up the two-line display.
2. Dial and press .
FCN 7
FCN
3 9 0
#
MENU
3 9 1
#
MENU
3 9 1 #