Introduction, Turning your endpoint on and off, Locking and unlocking the keypad on your endpoint – SpectraLink 8668 User Manual
Page 40
26
Inter-Tel
®
Model 8664/8665/8668 User Guide
GETTING ST
ARTED
I
NTRODUCTION
Now that you know what your Model 8664/8665/8668 endpoint can do, it’s time to
start using it. In this section, you’ll learn how to make and receive calls, transfer calls,
retrieve voice mail messages, and much more.
T
URNING
Y
OUR
E
NDPOINT
O
N
AND
O
FF
The
and
buttons are used to power on and power off the endpoint as well
as begin and end calls.
To turn the Model 8664/8665/8668 endpoint on:
Press and hold
(the Power On button) for about one second. Two chirps will
sound. When the button is released, the in-service tone sounds and the extension num-
ber is displayed. The endpoint is now in idle mode and ready to receive calls.
NOTE:
It is recommended that you keep your endpoint in idle mode (see
always return it to the charger when you are not using it.
To turn the Model 8664/8665/8668 endpoint off:
While in idle mode press and hold
(
the Power Off button). One chirp will
sound and the endpoint will turn off. The endpoint cannot be turned off during a call.
You must end the call before you can turn the endpoint off.
L
OCKING
AND
U
NLOCKING
THE
K
EYPAD
ON
Y
OUR
E
ND
-
POINT
To unlock the keypad:
Press the
Unlk
softkey, then
#
. The autolock feature of the keypad is disabled by
default.
To activate autolock:
See “Keypad Autolock” on