Shindaiwa 81646 - Manual (Page 10)

10
10
26123
26121
26122
Starting the Engine (continued)
WARNING!
Never start the engine from
the operating position.
WARNING!
The cutting attachment
may rotate when the
engine is started!
When the Engine Starts
n
After the engine starts, allow the
engine to warm up at idle or 3
minutes before operating the unit.
n After the engine is warm, pick up the
unit and clip on the shoulder strap if so
equipped. See page 11.
n Advancing the throttle makes the cut-
ting attachment turn faster; releasing
the throttle permits the attachment to
stop turning. If the cutting attachment
continues to rotate when the engine
returns to idle, carburetor idle speed
should be adjusted (see "Adjusting
Engine Idle" below).
IMPORTANT!
If the engine fails to start after several
attempts with the choke in the closed
position, the engine may be flooded
with fuel. If flooding is suspected,
move the choke lever to the open posi-
tion and repeatedly pull the recoil starter
to remove excess fuel and start the
engine. If the engine still fails to start,
refer to the troubleshooting section of
this manual.
5. When the engine starts, slowly move
the choke lever to the "OPEN" posi-
tion. See Figure 0. (If the engine
stops after the initial start, close the
choke and restart.)
Figure 20
Open
Idle the engine briefly before stopping
(about minutes), then slide the ignition
switch to the “O” (Engine OFF) position.
Stopping the Engine
Adjusting Engine Idle
Figure 21
Figure 22
Idle Adjusting
Screw
OFF
The engine must return to idle speed
whenever the throttle lever is released.
Idle speed is adjustable, and must be set
low enough to permit the engine clutch to
disengage the cutting attachment.
WARNING!
The cutting attachment must
NEVER rotate at engine
idle! If the idle speed cannot be
adjusted by the procedure described
here, return the trimmer to your
Shindaiwa dealer for inspection.
. If the attachment rotates when the
engine is at idle, reduce the idle speed
by turning the idle adjustment screw
counter-clockwise.
See Figure .
3. If a tachometer is available, the engine
idle speed should be final adjusted to
,750 (±50) rpm (min -1 ).
4. Carburetor fuel mixture adjustments
are preset at factory and cannot be
serviced in the field.
Idle Speed Adjustment
1. Place the trimmer on the ground, then
start the engine, and allow it to idle -3
minutes until warm.