Smeg DWD1E - Manual (Page 11)

User instructions
36
CHANGING THE PROGRAM
To change the program, press and hold down the START/STOP (5) button for a few seconds, then
select the new program as described previously in the instructions; press the START/STOP (5)
button again, holding it down for a few seconds.
DELAYED START
The start of the program can be delayed by 1, 2, 4, 6, 8 or 12 hours. In this way, it is possible to run
the dishwasher when most convenient.
Turn the DELAYED START selector (2 - 13) until it is aligned with the number of hours of delay
required before the program start.
This information automatically appears on the INFORMATION DISPLAY (8) as well. Then proceed
to select the program in the manner described previously: the dishwasher will immediately perform
a pre-wash cycle, and then automatically initiate the countdown of the delayed start programmed;
the INFORMATION DISPLAY (8) will show the time remaining to the start of the program.
T YPE "A" T YPE "B"
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
• Always try to run the dishwasher fully loaded.
• Do not wash the dishes in running water.
• Use the washing program that is most appropriate for each type of load.
• Do not carry out any preliminary rinsing.
• If available, connect the dishwasher to a hot water supply up to 60°C.
• When possible, disable the drying cycle and leave the door open at the end of the washing
cycle: the residual air and heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
• separate the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
• do not pour the detergent directly on the dishes.