Stamina Products 15-0200 - Manual (Page 11)

OPERATIONAL INSTRUCTIONS
SEAT ADJUSTMENT
CAUTION:
Loosen and pull the ADJUSTMENT KNOB(41), then slide
the SEAT FRAME(5) to adjust the seat.
Release and
t ighten the ADJUSTMENT KNOB(41) after adjusting the
seat to a new position.
Sit on the seat and place your feet on the pedals. You
should be able to move through a complete pedal stroke
without locking your knees or shifting your hips on the
seat. The seat is too close to the pedals if you have more
than a slight bend in your knees at the bottom of the pedal
stroke. The seat is too far from the pedals if you have to
completely straighten your knees at the bottom of the
pedal stroke. Refer to the illustration below.
1.
2.
Proper seat adjustment is important.
Do not attempt to adjust the seat while you are on the
INTONE Folding Recumbent Bike.
Always tighten the ADJUSTMENT KNOB(41) after
adjusting the seat to a new position. 1.
2.
To increase the load, turn the TENSION KNOB(29) counterclockwise.
To decrease the load, turn the TENSION KNOB(29) clockwise.
MAINTENANCE
The safety and integrity designed into the INTONE Folding Recumbent Bike can only be maintained
when the INTONE Folding Recumbent Bike is regularly examined for damage and wear. Special attention
should be given to the following:
Adjust the TENSION KNOB(29) and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten
loose nuts and bolts.
Worn or damaged components shall be replaced immediately or the INTONE Folding Recumbent
Bike removed from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the INTONE Folding
Recumbent Bike.
Keep your INTONE Folding Recumbent Bike clean by wiping with an absorbent cloth after use. 1.
2.
3.
4.
5.
6.
LOAD ADJUSTMENT
11