S/pdif input – SoundCraft DAKOTA 328 User Manual

Page 6

Dakota Setup Guide

Set the desired wordlength on the 328 with the rotary encoder.

Press the down cursor to set the port for 328 ADAT port B, as for port A, and again to set the

wordlength for port B. Press to confirm the settings.

The 328 S/PDIF input can be routed to any one of the following inputs:

Stereo Input 1, Stereo Input 2, FX Return 1, FX Return 2, 2 Track Tape Return,

providing that the AES/EBU input or oscillator has not already been assigned to that input.

Commonly the Dakota S/PDIF output would be routed to Stereo Input 2, or the 2 Track Tape

Return input.

Press

to enter the menu pages, scroll through the pages until the ‘SPDIF I/P Setup’ is

highlighted and press . Using the rotary encoder, select the destination for the
S/PDIF input, and press to confirm the setting:

< SPDIF Input >
Route To: STE-1

< SPDIF Input >
Route To: FX-1

< SPDIF Input >
Route To: 2TRK

< SPDIF Input >
Route To:NOWHERE

24 >
Wordlength: 24

S/PDIF Input

32 >

Bank Source:ADAT

32 >

Wordlength: 24

Assigning a digital source to an input will override any analogue signal

present on that input.

NOTE

If the S/PDIF input is not required, NOWHERE should be selected in the

menu.

NOTE