Sanyo CLT-2423 - Manual (Page 7)

BASICS
Receiving a call
When an incoming call is received, both handset and base screens
light and show caller information*. The incoming call LED on the
handset and the SPEAKER key on the base flash.
* A subscription is required from your local phone company to receive
Caller ID information on your phone. See
Caller ID Features , page 22.
Using handset:
1. Press TALK/CALL BACK to answer the call.
Note: If handset is in the base cradle, remove it from base before
pressing the TALK/CALL BACK key.
2. Press TALK/CALL BACK again to hang up.
Note: If you replace the handset to the base cradle, the handset
automatically hangs up.
Using base speakerphone:
1. Press SPEAKER to answer the call.
2. Press SPEAKER again to hang up.
Making a call
Using handset:
1. Press TALK/CALL BACK.
Note: If handset is in the base cradle, remove it from base before
pressing the TALK/CALL BACK key.
2. Dial the phone number.
The screen shows the number as you enter.
3. Press TALK/CALL BACK again to hang up.
13
Resetting to default
You can reset the phone programming to the initial factory default
settings.
The default settings are:
Language - E En ng gl li is sh h
Contrast - 2
Area Code - _
_ _ _ _ _
Ringer Tone - R Ri in ng ge er r T To on ne e 1 1
Time Set - 1 12 2: :0 00 0 A AM M
Default Set - 2 2 N NO O
1. Make sure the phone is OFF.
2. Press FLASH/PROGRAM on the base six times.
D
DE EF FA AU UL LT T S SE ET TT TI IN NG G 1 1Y YE ES S 2 2N NO O shows on screen.
3. Press CID ▲ or ▼, or the 1 or 2 key to select your choice.
4. Press FLASH/PROGRAM to confirm.
12
Telephone number
Channel No. Call timer Volume level
INITIAL PROGRAMMING
CLT-2419-2423E-NEW 3/14/03 3:32 PM Page 12