Sportline Solo 915 - Manual (Page 10)

7
ACQUIRING HEART RATE: FINGER TOUCH
Heart rate may be acquired from any operating mode (not in any Setting Sequence).
1. With the watch attached to your wrist,
TOUCH & HOLD the HEART RATE SENSOR (anywhere on the
metal top plate of the watch) with your index finger.
NOTE: If Heart Rate Sensors are accidentally touched, the watch will automatically attempt to acquire heart rate. If no heart rate is
detected, watch will resume operating mode in approximately 10 seconds. This will not interfere with any timing functions in progress.
NOTE: You may exit Heart Rate mode at any time by Pressing the Mode, Start/Stop or Reset key.
2. Continue TOUCHING & HOLDING until heart rate displays.
3. Once Heart Rate is acquired, RELEASE THE SENSOR . Heart Rate will continue to display for a period
of approximately 5 seconds.
NOTE: The Monitor displays both actual heart rate
(in beats per minute) and percent of estimated
maximum heart rate .
ACQUIRING HEART RATE
OR
SP4964IS03SPO.indd 7 SP4964IS03SPO.indd 7 7/28/10 3:42 PM 7/28/10 3:42 PM