Sanitaire 880 Series - Manual (Page 3)

GROUNDED
OUTLET BOX
FIGURE B
METAL
SCREW
ADAPTER
GROUNDING
TAB
GROUNDED
OUTLET BOX
FIGURE A
GROUNDING BLADE
IS LONGEST OF THE
THREE BLADES
Grounding Instructions
This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
DANGER
Improper connection of an equipment-grounding conductor can result in risk of electric shock. Check with a qualified electrician
or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the
appliance. If it will not fit the outlet, have proper outlet installed by a qualified technician.
This appliance is for use on a nominal 120 volt circuit and has a grounding plug that looks like the plug illustrated in Figure
A. A temporary adapter which looks like the adapter illustrated in Figure B may be used to connect this plug to a two-pole
receptacle, as shown, if a properly grounded outlet is not available. The temporary adapter should be used only until a properly
grounded outlet, Figure A, can be installed by a qualified electrician. The green colored rigid ear, lug, or the like extending
from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the
adapter is used, it must be held in place by a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.
3
HOW TO ASSEMBLE
CAUTION: Fully assemble the cleaner before using.
Assembly Packet for 680 Series
The assembly packet contains two 2-part handle bolts (A), 2 cord hooks
(B), 2 bellows screws (C) and 1 cord clamp with a screw (D). An extra
belt is included with some models.
Assembly Packet for 880 Series
The assembly packet contains two 2-part handle bolts (E), 2 cord hooks
(F), 2 bellows screws (G) and 1 cord clamp with a screw (H). An extra
belt is included with some models.
Secure Bellows
Check to be sure the end of the bellows is secure
in the chrome bellows adapter. Align the screw
holes in the bellows adapter with the back of the
base, start the screws (C) by hand, and tighten with
screw driver.
A
2-Part
Handle
Bolts
B
Cord
Hooks
C
Bellows
Screws
D
Cord
Clamp
and
Screw
G
Bellows
Screws
F
Cord
Hook
E
2-Part
Handle
Bolts
H
Cord
Clamp
and
Screw