beautypg.com

Preparing the remote controller – Sherwood VD-4500 User Manual

Page 13

background image

Preparing the Remote Controller

12

Remove the battery compartment cover by
pressing the tab and lifting up the cover.

Insert the two batteries (size AAA/R3).

Be sure to match the + and – ends of the batteries with
the diagram inside the battery compartment.

Replace the battery compartment cover.

Notes

• Do not mix new batteries with old batteries or different

kinds of batteries.

• To avoid corrosion, remove the batteries if the remote

controller is not to be used for a long time.

• Remove dead batteries immediately to avoid damage

from corrosion. If the remote controller does not
operate smoothly, replace both batteries at the same
time.

• The life of the batteries supplied is about six months

but this will vary depending on usage.

Point the remote controller toward the remote control
sensor.

Notes

• Place the unit away from strong light such as direct

sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.

• Using another remote controller of the same type in

the same room or using the unit near equipment which
uses infrared rays may cause operational interference.

• Do not put any object such as a book on the remote

controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.

• Make sure the audio rack doors do not have colored

glass. Placing the unit behind such doors may prevent
proper remote controller operation.

• If there is any obstacle between the remote controller

and the remote control sensor, the remote controller
will not operate.

Inserting the Batteries

Using the Remote Controller