Snapper 42" Single-Stage Snowthrower - Manual (Page 23)

21
Removal
7. Disconnect the final wiring harness (B, Figure 24).
8. Remove both quick clips (E, Figure 25) and snow
thrower mounting pins (D).
9. Move the snow thrower assembly (A, Figure 25) out
of the way.
10. Turn the front wheels fully to the left. Remove the
latch pin quick clip (D, Figure 26) and slide the latch
pin (A) to the left.
CAUTION
Make sure to support the front of the hitch
assembly as it will be loose when the latch pin
has been removed.
A
B
C
D
Figure 24. Belt Routing
A. Upper Wiring Harness
B. Final Wiring Harness
C. Mounting Clip
D. Chute Rotation Motor Connector
C
A
D
B
Figure 26. Latch Pin Removal
A. Hitch Latch Pin
B. Hitch
C. Frame Support Fingers
D. Quick Clips
A
B
C
D
D
E
E
Figure 25. Snow Thrower Installation
A. Snow Thrower Assembly
B. Hitch Mounting Arms
C. Snow Thrower Mounting Tabs
D. Mounting Pins
E. Quick Clips