Sony SA-VE230 - Manual (Page 10)

10
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 6 ohm loads both channels driven, from
20 - 150 Hz; rated 50 watts per channel
minimum RMS power, with no more than
0.8% total harmonic distortion from
250 milliwatts to rated output.
SS-V230 Front and rear speakers
Speaker system Full range, magnetically
shielded
Speaker units 5
×
9 cm (2
×
3 5 /
8
in.),
cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power:
100 watts
Sensitivity level 86 dB (1 W, 1 m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 70
Ч
151
Ч
126 mm (2 7 / 8
Ч
6
Ч
5 in.),
including front grille
Mass Approx. 550 g (1 lb 3 oz)
each
SS-CN230 Center speaker
Speaker system Full range
×
2,
magnetically shielded
Speaker units 5
×
9 cm (2
×
3 5 / 8 in.),
cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power:
120 watts
Sensitivity level 88 dB (1 W, 1 m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 301
Ч
70
Ч
126 mm (11 7 /
8
Ч
2 7 /
8
Ч
5 in.), including front
grille
Mass Approx. 1.1 kg (2 lb 7 oz)
SA-WMS230 Subwoofer
System
Speaker system
Active subwoofer,
magnetically shielded
Speaker unit Woofer: 16 cm (6 3 /
8
in.),
cone type
Enclosure type Advanced SAW type
Continuous RMS power output
(8 ohms, 20 - 150 Hz, 0.8 % THD)
50 W
Reproduction frequency range
28 Hz - 200 Hz
High frequency cut-off frequency
200 Hz
Input
LINE IN (input pin jack)
General
Power requirements
120 V AC, 60 Hz
Power consumptions 45 W
Dimensions (w/h/d) Approx. 205
Ч
385
Ч
385 mm (8 1 /
8
Ч
15 1 /
4
Ч
15 1 /
4
in.), including
front grille
Mass Approx. 10.5 kg
(23 lb 2 oz)
Supplied accessories
Foot pads (20)
Audio connecting cords (2 phono to 2 phono) (3)
Monaural connecting cord (1 phono to 1 phono)
(1)
Speaker connecting cords, 10 m
(32 ft 9 3 /
4
in.) (2)
Speaker connecting cords, 2.5 m
(8 ft 2 1 /
2
in.) (3)
Design and specifications are subject to change
without notice.