Shoprider 858WM - Manual (Page 14)

3/28/2008 14
The Powerchair will not function while the drive
mechanism is disengaged (in freewheel).
Both left and right sides must be in drive mode for power chair
to operate. Otherwise the Powerchair motors will spin, but the
unit will not move, until both freewheel levers are engaged. Unit
will spin in circles if only one side is in drive mode.
*** DO NOT PUT INTO DRIVE MODE WHILE MOTORS ARE
SPINNING ****
6Runner – 888WNLM, 888WNLLHD & 858WM
The drive/freewheel levers are found toward the rear of the Powerchair
on 888WNLM and 888WNLLHD (Figure 4A). On the 858WM freewheel
levers are located under the front part of the seat (Figure 4B), both
have yellow colored handles. These levers will allow you to disengage
the drive mechanism (When the levers are pulled out away from the
unit) the Powerchair is in freewheel mode. ***NOTE*** the VSI will not
work in Freewheel mode. When the levers are pushed in (towards the
inside of the unit) the motors are engaged and the powerchair is in drive
mode.
Freewheel lever **NOTE** There is a lever on opposite side
FIGURE 4A
Sticker will also help indicate in which position
the brakes are locked or unlocked.
FIGURE 4B
Freewheel lever