Source Technologies ETC 470 - Manual (Page 4)

2 Source Four CE User Manual
English
Source Four CE guidelines
The Source Four CE is intended for professional use only. Read the entire User Guide before
using equipment.
• Do not mount the Source Four CE on or near a flammable surface.
• Use the Source Four CE in dry locations only, where humidity does not exceed 90
percent.
• The luminaire is for indoor use only and is not intended for outdoor use.
• For temporary installations, mount and support the Source Four CE only by the primary
suspension yoke holes. Suspend the luminaire from a hook clamp or a stand mount,
using a securely tightened steel bolt (up to Ø 12 mm), flat washer and locking washer.
• In addition to primary suspension, attach a safety cable (ETC part #7060A1022) or
chain to the secondary suspension point on the Source Four CE.
• If the external cable is damaged, it shall be replaced by ETC or our service agents.
• Always hang the Source Four CE with the colour frame held securely behind the
retaining clip.
• Always replace the lamp if it becomes damaged or thermally deformed.
• Disconnect the unit from power before all cleaning and maintenance.
• The Source Four CE is suitable for indoor use with a maximum ambient temperature:
T
a
=45 C
• Maximum exterior surface temperature: T
max
=217ºC
• A multilingual label sheet is included with this manual. Affix the label of the appropriate
language over the existing warning label on the extension yoke. Do not cover ETC
trademark or CE mark.
• The Source Four CE is equipped with a safety screen that covers the lens to prevent
injury from broken glass due to lamp failure. Do not remove this safety screen.
• Keep the luminaire at least 0.8 meters away from any lit surface. Lighted objects at this
distance or greater will not exceed 90ºC temperature from projected light.
W A R N I N G : Please note the following safety precautions.
0.8m